Density

The mechanical power requirement of a centrifugal pump (shaft power) is directly proportional to the density of the pumped medium. P 2 ~ ρP 2 = shaft power ρ = density of the pumped mediumIn contrast, the throttle curve of the pump H (Q) and the efficiency η (Q) are independent of the density.These relationships are automatically taken into account by the pump selection software.

Pumped medium

In particular, the following criteria must be taken into account:(1) General suitability of the pump type In principle, centrifugal pumps are only suitable up to a certain viscosity, which depends on the size. A positive displacement pump should be selected for very high viscosities.(2) Pump characteristics The pump characteristics are usually measured with water under standard conditions. If the density and viscosity are different, the characteristics must be converted accordingly. This is usually done automatically by the pump selection software if it is a Newtonian fluid.(3) Material selection The selection of suitable materials is extremely important, especially if the pumped medium contains abrasive or aggressive components. Many manufacturers offer media resistance information for this. For such use, however, direct contact with the manufacturer is definitely recommended.(4) Seal selection In addition to the media-material resistance, the characteristics of the pumped medium must be taken into account when selecting a suitable seal. In the case of dangerous substances (e.g. toxic or explosive media) or particularly valuable fluids, it is usually necessary to use a leak-free solution. Pumps without a shaft seal with a canned motor or magnetic coupling are ideal here.(5) Solid or gas fractions If the pumped medium contains solid and / or gas components, special pump designs that are intended for this must be selected. For example, suitable impellers prevent the pump from blocking when there are solid or fibrous components. Gas proportions affect the suction behavior of centrifugal pumps. A higher gas content leads to an increase in the required NPSH value and thus to the earlier occurrence of cavitation.