|
10.11.2003 New SAER 4 Submersible Motors |
||||||||||||||||||||||
|
SAER Elettropompe Srl, profiting from its experience of many years in the production of 6-8-10 and 12 submersible motors, has now introduced the new series of 4 motors. The new 4 motor, series CL 95, has been studied based on EASINESS principles:
It is a motor with good performances, produced with updated technologies which assure excellent quality and high reliability. Asynchronus motor, with squirrel cage rotor, single phase (PSC) and three phase version. Single phase:
Three phase:
The single phase motors are of permanent split capacitor type (PSC), with external capacitor to be installed in the control panel. The CL 95 motor is an oil filled motor, filled with atoxic liquid, pollution free, approved by American FDA standards. The external shell, the shaft end and the lower cover are in stainless steel. The upper support is made of brass. In the lower part there is a compensation membrane, rightly sized to absorb the normal thermal expansions of the internal liquid. The stator, easily removable, is wound with a normal enamelled wire, insulation Class F. The rotors are of die-cast aluminium up to 3HP, for higher power the cage is made of copper. The bearings are of a sliding type, widely sized to bear the axial load of the pumps: -- 150 kg for motors up to 3 HP. -- 450 kg for motors higher than 3 HP The bearings are of selected quality, but of regular production and therefore easy to find in every country. The seal of the shaft is of mechanical type, with a sand guard. The motor is supplied with a quadripole flat cable lead (3+1) , section 2 mm², length 1,5 meters, with a special plug for direct fitting to the motor. coupling: shaft end and flange according to NEMA standards protection: IP 68 service: continuous insulation: class F max. external water temperature: 30 °C SAER |
| |||||||||||||||||||||
| [ Home ] [ Pump Magazine ] [ Virtual exhibition ] [ Encyclopedia ] [ PumpSelector ] [ Impressum ] |